AZL-115393: CVE-2026-99614 affecting package kernel 6.6.161.1-1
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/nvkm: clear use.enabled when subdev init fails
On Kepler boards without the video decode falcon firmware installed (msvld/mspdec/msppp), every other VA-API decode attempt binds to an engine with no ucode loaded. The submitted work never completes, which leads to a context switch timeout, a channel recovery that cannot reset the engine, and eviction waits on fences that never signal. The process ends up stuck in D state, or killed by SIGBUS when it touches a buffer evicted after the wait times out:
msvld: unable to load firmware data msvld: init failed, -19 fifo: SCHEDERROR 0a [CTXSWTIMEOUT] vo[5444]: channel 14 killed! WARNING: drivers/gpu/drm/nouveau/nvkm/engine/fifo/runl.c:117 at nvkmrunlrc+0x2a4/0x3b0 [nouveau] [TTM] Buffer eviction failed WARNING: drivers/gpu/drm/nouveau/nouveaubo.c:1092 at nouveaubomoventfy.part.0+0x9b/0x100 [nouveau]
Tracing nvkmsubdevref() and nvkmsubdevinit() shows the pattern: a reference taken with enabled=0 runs nvkmfalconinit(), which returns -ENODEV; the next reference sees enabled=1 and succeeds without running it.
Clear use.enabled when init() fails, so that every later reference retries init and fails cleanly. The other readers of use.enabled are fini() handlers that use it to skip teardown, which they now also do after a failed init().
On a GK107 (Quadro K1100M) without video firmware, playing H.264 with mpv --hwdec=auto: without this patch the GPU channel is killed within a minute and mpv hangs; with it, VA-API decoder creation fails, mpv falls back to software decoding, and no faults are logged.
Affected Software
Remediation
Recommended actions to resolve this vulnerability, in priority order.
- Compensating control
In the Nouveau driver, clear use.enabled when subdevice init() fails so later references retry initialization.