An attacker is able to remotely inject arbitrary commands by sending especially crafted packets destined to the PAPI (Aruba Networks AP Management protocol) UDP port (8211) of access-pointsor controllers in Aruba 9000 Gateway; Aruba 7000 Series Mobility Controllers; Aruba 7200 Series Mobility Controllers version(s): 2.1.0.1, 2.2.0.0 and below; 6.4.4.23, 6.5.4.17, 8.2.2.9, 8.3.0.13, 8.5.0.10, 8.6.0.5, 8.7.0.0 and below ; 6.4.4.23, 6.5.4.17, 8.2.2.9, 8.3.0.13, 8.5.0.10, 8.6.0.5, 8.7.0.0 and below.
There are multiple buffer overflow vulnerabilities that could lead to unauthenticated remote code execution by sending especially crafted packets destined to the PAPI (Aruba Networks AP management protocol) UDP port (8211) of access-points or controllers in Aruba 9000 Gateway; Aruba 7000 Series Mobility Controllers; Aruba 7200 Series Mobility Controllers version(s): 2.1.0.1, 2.2.0.0 and below; 6.4.4.23, 6.5.4.17, 8.2.2.9, 8.3.0.13, 8.5.0.10, 8.6.0.5, 8.7.0.0 and below; 6.4.4.23, 6.5.4.17, 8.2.2.9, 8.3.0.13, 8.5.0.10, 8.6.0.5, 8.7.0.0 and below.
A remote code execution vulnerability is present in network-listening components in some versions of ArubaOS. An attacker with the ability to transmit specially-crafted IP traffic to a mobility controller could exploit this vulnerability and cause a process crash or to execute arbitrary code within the underlying operating system with full system privileges. Such an attack could lead to complete system compromise. The ability to transmit traffic to an IP interface on the mobility controller is required to carry out an attack. The attack leverages the PAPI protocol (UDP port 8211). If the mobility controller is only bridging L2 traffic to an uplink and does not have an IP address that is accessible to the attacker, it cannot be attacked.
A vulnerability exists in the firmware of embedded BLE radios that are part of some Aruba Access points. An attacker who is able to exploit the vulnerability could install new, potentially malicious firmware into the AP's BLE radio and could then gain access to the AP's console port. This vulnerability is applicable only if the BLE radio has been enabled in affected access points. The BLE radio is disabled by default. Note - Aruba products are NOT affected by a similar vulnerability being tracked as CVE-2018-16986.