A vulnerability in the logic that handles access control to one of the hardware components in Cisco's proprietary Secure Boot implementation could allow an authenticated, local attacker to write a modified firmware image to the component. This vulnerability affects multiple Cisco products that support hardware-based Secure Boot functionality. The vulnerability is due to an improper check on the area of code that manages on-premise updates to a Field Programmable Gate Array (FPGA) part of the Secure Boot hardware implementation. An attacker with elevated privileges and access to the underlying operating system that is running on the affected device could exploit this vulnerability by writing a modified firmware image to the FPGA. A successful exploit could either cause the device to become unusable (and require a hardware replacement) or allow tampering with the Secure Boot verification process, which under some circumstances may allow the attacker to install and boot a malicious software image. An attacker will need to fulfill all the following conditions to attempt to exploit this vulnerability: Have privileged administrative access to the device. Be able to access the underlying operating system running on the device; this can be achieved either by using a supported, documented mechanism or by exploiting another vulnerability that would provide an attacker with such access. Develop or have access to a platform-specific exploit. An attacker attempting to exploit this vulnerability across multiple affected platforms would need to research each one of those platforms and then develop a platform-specific exploit. Although the research process could be reused across different platforms, an exploit developed for a given hardware platform is unlikely to work on a different hardware platform.

A vulnerability in the UDP processing functionality of Cisco IOS XE Software for Embedded Wireless Controllers on Catalyst 9100 Series Access Points could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition. This vulnerability is due to the improper processing of UDP datagrams. An attacker could exploit this vulnerability by sending malicious UDP datagrams to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

A vulnerability in the processing of malformed Common Industrial Protocol (CIP) packets that are sent to Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to unexpectedly reload, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient input validation during processing of CIP packets. An attacker could exploit this vulnerability by sending a malformed CIP packet to an affected device. A successful exploit could allow the attacker to cause the affected device to unexpectedly reload, resulting in a DoS condition.

A vulnerability in the DNS application layer gateway (ALG) functionality that is used by Network Address Translation (NAT) in Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload. This vulnerability is due to a logic error that occurs when an affected device inspects certain TCP DNS packets. An attacker could exploit this vulnerability by sending crafted DNS packets through the affected device that is performing NAT for DNS packets. A successful exploit could allow the attacker to cause the device to reload, resulting in a denial of service (DoS) condition on the affected device. Note: This vulnerability can be exploited only by sending IPv4 TCP packets through an affected device. This vulnerability cannot be exploited by sending IPv6 traffic.

A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform a directory traversal and access resources that are outside the filesystem mountpoint of the web UI. This vulnerability is due to an insufficient security configuration. An attacker could exploit this vulnerability by sending a crafted request to the web UI. A successful exploit could allow the attacker to gain read access to files that are outside the filesystem mountpoint of the web UI. Note: These files are located on a restricted filesystem that is maintained for the web UI. There is no ability to write to any files on this filesystem.

A vulnerability in the Multicast Leaf Recycle Elimination (mLRE) feature of Cisco IOS XE Software for Cisco ASR 1000 Series Aggregation Services Routers could allow an unauthenticated, remote attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability is due to incorrect handling of certain IPv6 multicast packets when they are fanned out more than seven times on an affected device. An attacker could exploit this vulnerability by sending a specific IPv6 multicast or IPv6 multicast VPN (MVPNv6) packet through the affected device. A successful exploit could allow the attacker to cause a reload of the affected device, resulting in a DoS condition.

A vulnerability in the Cisco IOx application hosting subsystem of Cisco IOS XE Software could allow an authenticated, local attacker to elevate privileges to root on an affected device. This vulnerability is due to insufficient restrictions on the hosted application. An attacker could exploit this vulnerability by logging in to and then escaping the Cisco IOx application container. A successful exploit could allow the attacker to execute arbitrary commands on the underlying operating system with root privileges.