A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform a directory traversal and access resources that are outside the filesystem mountpoint of the web UI. This vulnerability is due to an insufficient security configuration. An attacker could exploit this vulnerability by sending a crafted request to the web UI. A successful exploit could allow the attacker to gain read access to files that are outside the filesystem mountpoint of the web UI. Note: These files are located on a restricted filesystem that is maintained for the web UI. There is no ability to write to any files on this filesystem.

A vulnerability in the Cisco IOx application hosting subsystem of Cisco IOS XE Software could allow an authenticated, local attacker to elevate privileges to root on an affected device. This vulnerability is due to insufficient restrictions on the hosted application. An attacker could exploit this vulnerability by logging in to and then escaping the Cisco IOx application container. A successful exploit could allow the attacker to execute arbitrary commands on the underlying operating system with root privileges.

A vulnerability in the password-recovery disable feature of Cisco IOS XE ROM Monitor (ROMMON) Software for Cisco Catalyst Switches could allow an unauthenticated, local attacker to recover the configuration or reset the enable password. This vulnerability is due to a problem with the file and boot variable permissions in ROMMON. An attacker could exploit this vulnerability by rebooting the switch into ROMMON and entering specific commands through the console. A successful exploit could allow the attacker to read any file or reset the enable password.

A vulnerability in the egress MPLS packet processing function of Cisco IOS XE Software for Cisco Catalyst 3650, Catalyst 3850, and Catalyst 9000 Family Switches could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient input validation of IPv4 traffic. An attacker could exploit this vulnerability by sending a malformed packet out of an affected MPLS-enabled interface. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

A vulnerability in the processing of malformed Common Industrial Protocol (CIP) packets that are sent to Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to unexpectedly reload, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient input validation during processing of CIP packets. An attacker could exploit this vulnerability by sending a malformed CIP packet to an affected device. A successful exploit could allow the attacker to cause the affected device to unexpectedly reload, resulting in a DoS condition.

A vulnerability in the web UI feature of Cisco IOS XE Software could allow an authenticated, remote attacker to perform an injection attack against an affected device. This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending crafted input to the web UI API. A successful exploit could allow the attacker to execute arbitrary commands on the underlying operating system with root privileges. To exploit this vulnerability, an attacker must have valid Administrator privileges on the affected device.

A vulnerability in the UDP processing functionality of Cisco IOS XE Software for Embedded Wireless Controllers on Catalyst 9100 Series Access Points could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition. This vulnerability is due to the improper processing of UDP datagrams. An attacker could exploit this vulnerability by sending malicious UDP datagrams to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

Layer 2 network filtering capabilities such as IPv6 RA guard or ARP inspection can be bypassed using combinations of VLAN 0 headers and LLC/SNAP headers.

Multiple vulnerabilities in the Cisco IOx application hosting environment on multiple Cisco platforms could allow an attacker to inject arbitrary commands into the underlying host operating system, execute arbitrary code on the underlying host operating system, install applications without being authenticated, or conduct a cross-site scripting (XSS) attack against a user of the affected software. For more information about these vulnerabilities, see the Details section of this advisory.

A vulnerability in the Internet Key Exchange Version 2 (IKEv2) support for the AutoReconnect feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to exhaust the free IP addresses from the assigned local pool. This vulnerability occurs because the code does not release the allocated IP address under certain failure conditions. An attacker could exploit this vulnerability by trying to connect to the device with a non-AnyConnect client. A successful exploit could allow the attacker to exhaust the IP addresses from the assigned local pool, which prevents users from logging in and leads to a denial of service (DoS) condition.

A vulnerability in the Link Layer Discovery Protocol (LLDP) message parser of Cisco IOS Software and Cisco IOS XE Software could allow an attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. This vulnerability is due to improper initialization of a buffer. An attacker could exploit this vulnerability via any of the following methods: An authenticated, remote attacker could access the LLDP neighbor table via either the CLI or SNMP while the device is in a specific state. An unauthenticated, adjacent attacker could corrupt the LLDP neighbor table by injecting specific LLDP frames into the network and then waiting for an administrator of the device or a network management system (NMS) managing the device to retrieve the LLDP neighbor table of the device via either the CLI or SNMP. An authenticated, adjacent attacker with SNMP read-only credentials or low privileges on the device CLI could corrupt the LLDP neighbor table by injecting specific LLDP frames into the network and then accessing the LLDP neighbor table via either the CLI or SNMP. A successful exploit could allow the attacker to cause the affected device to crash, resulting in a reload of the device.

A vulnerability in the IP Service Level Agreement (SLA) responder feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause the IP SLA responder to reuse an existing port, resulting in a denial of service (DoS) condition. The vulnerability exists because the IP SLA responder could consume a port that could be used by another feature. An attacker could exploit this vulnerability by sending specific IP SLA control packets to the IP SLA responder on an affected device. The control packets must include the port number that could be used by another configured feature. A successful exploit could allow the attacker to cause an in-use port to be consumed by the IP SLA responder, impacting the feature that was using the port and resulting in a DoS condition.

A vulnerability in the Umbrella Connector component of Cisco IOS XE Software for Cisco Catalyst 9200 Series Switches could allow an unauthenticated, remote attacker to trigger a reload, resulting in a denial of service condition on an affected device. The vulnerability is due to insufficient error handling when parsing DNS requests. An attacker could exploit this vulnerability by sending a series of malicious DNS requests to an Umbrella Connector client interface of an affected device. A successful exploit could allow the attacker to cause a crash of the iosd process, which triggers a reload of the affected device.