Multiple Cisco products are affected by a vulnerability with TCP Fast Open (TFO) when used in conjunction with the Snort detection engine that could allow an unauthenticated, remote attacker to bypass a configured file policy for HTTP. The vulnerability is due to incorrect detection of the HTTP payload if it is contained at least partially within the TFO connection handshake. An attacker could exploit this vulnerability by sending crafted TFO packets with an HTTP payload through an affected device. A successful exploit could allow the attacker to bypass configured file policy for HTTP packets and deliver a malicious payload.

Multiple Cisco products are affected by a vulnerability in the Snort application detection engine that could allow an unauthenticated, remote attacker to bypass the configured policies on an affected system. The vulnerability is due to a flaw in the detection algorithm. An attacker could exploit this vulnerability by sending crafted packets that would flow through an affected system. A successful exploit could allow the attacker to bypass the configured policies and deliver a malicious payload to the protected network.

Multiple Cisco products are affected by a vulnerability in the Snort detection engine that could allow an unauthenticated, remote attacker to bypass a configured file policy for HTTP. The vulnerability is due to incorrect handling of specific HTTP header parameters. An attacker could exploit this vulnerability by sending crafted HTTP packets through an affected device. A successful exploit could allow the attacker to bypass a configured file policy for HTTP packets and deliver a malicious payload.

A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position.

Multiple Cisco products are affected by a vulnerability in Snort access control policies that could allow an unauthenticated, remote attacker to bypass the configured policies on an affected system. This vulnerability is due to a logic error that occurs when the access control policies are being populated. An attacker could exploit this vulnerability by establishing a connection to an affected device. A successful exploit could allow the attacker to bypass configured access control rules on the affected system.

A vulnerability in the Cisco Group Encrypted Transport VPN (GET VPN) feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker who has administrative control of either a group member or a key server to execute arbitrary code on an affected device or cause the device to crash. This vulnerability is due to insufficient validation of attributes in the Group Domain of Interpretation (GDOI) and G-IKEv2 protocols of the GET VPN feature. An attacker could exploit this vulnerability by either compromising an installed key server or modifying the configuration of a group member to point to a key server that is controlled by the attacker. A successful exploit could allow the attacker to execute arbitrary code and gain full control of the affected system or cause the affected system to reload, resulting in a denial of service (DoS) condition. For more information, see the Details ["#details"] section of this advisory.

A vulnerability in the Autonomic Networking feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, adjacent attacker to cause autonomic nodes of an affected system to reload, resulting in a denial of service (DoS) condition. More Information: CSCvd88936. Known Affected Releases: Denali-16.2.1 Denali-16.3.1.

A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS XE 3.16 could allow an authenticated, remote attacker to cause a denial of service (DoS) condition. The vulnerability is due to a race condition that could occur when the affected software processes an SNMP read request that contains certain criteria for a specific object ID (OID) and an active crypto session is disconnected on an affected device. An attacker who can authenticate to an affected device could trigger this vulnerability by issuing an SNMP request for a specific OID on the device. A successful exploit will cause the device to restart due to an attempt to access an invalid memory region. The attacker does not control how or when crypto sessions are disconnected on the device. Cisco Bug IDs: CSCvb94392.

A vulnerability in a startup script of Cisco IOS XE Software could allow an unauthenticated attacker with physical access to the targeted system to execute arbitrary commands on the underlying operating system with the privileges of the root user. More Information: CSCuz06639 CSCuz42122. Known Affected Releases: 15.6(1.1)S 16.1.2 16.2.0 15.2(1)E. Known Fixed Releases: Denali-16.1.3 16.2(1.8) 16.1(2.61) 15.6(2)SP 15.6(2)S1 15.6(1)S2 15.5(3)S3a 15.5(3)S3 15.5(2)S4 15.5(1)S4 15.4(3)S6a 15.4(3)S6 15.3(3)S8a 15.3(3)S8 15.2(5)E 15.2(4)E3 15.2(3)E5 15.0(2)SQD3 15.0(1.9.2)SQD3 3.9(0)E.

A vulnerability in the Autonomic Networking Infrastructure (ANI) feature of Cisco IOS Software (15.4 through 15.6) and Cisco IOS XE Software (3.7 through 3.18, and 16) could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition. The vulnerability is due to incomplete input validation on certain crafted packets. An attacker could exploit this vulnerability by sending a crafted IPv6 packet to a device that is running a Cisco IOS Software or Cisco IOS XE Software release that supports the ANI feature. A device must meet two conditions to be affected by this vulnerability: (1) the device must be running a version of Cisco IOS Software or Cisco IOS XE Software that supports ANI (regardless of whether ANI is configured); and (2) the device must have a reachable IPv6 interface. An exploit could allow the attacker to cause the affected device to reload. Cisco Bug IDs: CSCvc42729.

A vulnerability in Simple Network Management Protocol (SNMP) functions of Cisco ASR 1000 Series Aggregation Services Routers running Cisco IOS XE Software Release 3.13.6S, 3.16.2S, or 3.17.1S could allow an authenticated, remote attacker to cause high CPU usage on an affected device, resulting in a denial of service (DoS) condition. More Information: CSCux68796. Known Affected Releases: 15.5(3)S2.1 15.6(1)S1.1. Known Fixed Releases: 15.4(3)S6.1 15.4(3)S6.2 15.5(3)S2.2 15.5(3)S3 15.6(0.22)S0.23 15.6(1)S2 16.2(0.295) 16.3(0.94) 15.5.3S3.

A vulnerability in the handling of list headers in Cisco cBR Series Converged Broadband Routers could allow an unauthenticated, remote attacker to cause the device to reload, resulting in a denial of service (DoS) condition. Cisco cBR-8 Converged Broadband Routers running vulnerable versions of Cisco IOS XE are affected. More Information: CSCux40637. Known Affected Releases: 15.5(3)S 15.6(1)S. Known Fixed Releases: 15.5(3)S2 15.6(1)S1 15.6(2)S 15.6(2)SP 16.4(1).

A vulnerability in the Border Gateway Protocol (BGP) over an Ethernet Virtual Private Network (EVPN) for Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause the device to reload, resulting in a denial of service (DoS) condition, or potentially corrupt the BGP routing table, which could result in network instability. The vulnerability exists due to changes in the implementation of the BGP MPLS-Based Ethernet VPN RFC (RFC 7432) draft between IOS XE software releases. When the BGP Inclusive Multicast Ethernet Tag Route or BGP EVPN MAC/IP Advertisement Route update packet is received, it could be possible that the IP address length field is miscalculated. An attacker could exploit this vulnerability by sending a crafted BGP packet to an affected device after the BGP session was established. An exploit could allow the attacker to cause the affected device to reload or corrupt the BGP routing table; either outcome would result in a DoS. The vulnerability may be triggered when the router receives a crafted BGP message from a peer on an existing BGP session. This vulnerability affects all releases of Cisco IOS XE Software prior to software release 16.3 that support BGP EVPN configurations. If the device is not configured for EVPN, it is not vulnerable. Cisco Bug IDs: CSCui67191, CSCvg52875.

The L2TP module in Cisco IOS XE 3.10S(.2) and earlier on ASR 1000 routers allows remote authenticated users to cause a denial of service (ESP card reload) via a malformed L2TP packet, aka Bug ID CSCun09973.

The IKE implementation in Cisco IOS 15.4(1)T and earlier and IOS XE allows remote attackers to cause a denial of service (security-association drop) via crafted Main Mode packets, aka Bug ID CSCun31021.

The VTY authentication implementation in Cisco IOS XE 03.02.xxSE and 03.03.xxSE incorrectly relies on the Linux-IOS internal-network configuration, which allows remote attackers to bypass authentication by leveraging access to a 192.168.x.2 source IP address, aka Bug ID CSCuj90227.

Cisco IOS XE 3.7S(.1) and earlier allows remote attackers to cause a denial of service (Packet Processor crash) via fragmented MPLS IP packets, aka Bug ID CSCul00709.

The IP Device Tracking (IPDT) feature in Cisco IOS and IOS XE allows remote attackers to cause a denial of service (IPDT AVL corruption and device reload) via a crafted sequence of ARP packets, aka Bug ID CSCuh38133.

The Cisco Express Forwarding processing module in Cisco IOS XE allows remote attackers to cause a denial of service (device reload) via crafted MPLS packets that are not properly handled during IP header validation, aka Bug ID CSCuj23992.

Cisco IOS XE 3.8S(.2) and earlier does not properly use a DHCP pool during assignment of an IP address, which allows remote authenticated users to cause a denial of service (device reload) via an AAA packet that triggers an address requirement, aka Bug ID CSCuh04949.

Cisco ASR 1000 devices with software before 3.8S, when BDI routing is enabled, allow remote attackers to cause a denial of service (device reload) via crafted (1) broadcast or (2) multicast ICMP packets with fragmentation, aka Bug ID CSCub55948.

The mDNS implementation in Cisco IOS XE 3.12S does not properly interact with autonomic networking, which allows remote attackers to obtain sensitive networking-services information by sniffing the network or overwrite networking-services data via a crafted mDNS response, aka Bug ID CSCun64867.

The Locator/ID Separation Protocol (LISP) implementation in Cisco IOS 15.3(3)S and earlier and IOS XE does not properly validate parameters in ITR control messages, which allows remote attackers to cause a denial of service (CEF outage and packet drops) via malformed messages, aka Bug ID CSCun73782.

The SNMP module in Cisco IOS XE 3.5E allows remote authenticated users to cause a denial of service (device reload) by polling frequently, aka Bug ID CSCug65204.

Cisco IOS XE on ASR1000 devices, when PPPoE termination is enabled, allows remote attackers to cause a denial of service (device reload) via a malformed PPPoE packet, aka Bug ID CSCuo55180.

A vulnerability in the bootstrap loading of Cisco IOS XE Software could allow an authenticated, local attacker to write arbitrary files to an affected system. This vulnerability is due to insufficient input validation of the bootstrap file that is read by the system software when a device is first deployed in SD-WAN mode or when an administrator configures SD-Routing on the device. An attacker could exploit this vulnerability by modifying a bootstrap file generated by Cisco Catalyst SD-WAN Manager, loading it into the device flash, and then either reloading the device in a green field deployment in SD-WAN mode or configuring the device with SD-Routing. A successful exploit could allow the attacker to perform arbitrary file writes to the underlying operating system.

A vulnerability in the CLI of Cisco IOS XE Software could allow an authenticated, local attacker with privilege level 15 to elevate privileges to root on the underlying operating system of an affected device. This vulnerability is due to insufficient input validation when processing specific configuration commands. An attacker could exploit this vulnerability by including crafted input in specific configuration commands. A successful exploit could allow the attacker to elevate privileges to root on the underlying operating system of an affected device. The security impact rating (SIR) of this advisory has been raised to High because an attacker could gain access to the underlying operating system of the affected device and perform potentially undetected actions. Note: The attacker must have privileges to enter configuration mode on the affected device. This is usually referred to as privilege level 15.

A vulnerability in the web-based management interface of Cisco IOS XE Software could allow an authenticated, low-privileged, remote attacker to perform an injection attack against an affected device. This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending crafted input to the web-based management interface. A successful exploit could allow the attacker to read limited files from the underlying operating system or clear the syslog and licensing logs on the affected device.

A vulnerability in the CLI of Cisco IOS XE Software could allow an authenticated, local attacker with administrative privileges to execute arbitrary commands as root on the underlying operating system of an affected device. This vulnerability is due to insufficient validation of user arguments that are passed to specific CLI commands. An attacker could exploit this vulnerability by logging in to the device CLI with valid administrative (level 15) credentials and using crafted commands at the CLI prompt. A successful exploit could allow the attacker to execute arbitrary commands as root.

Layer 2 network filtering capabilities such as IPv6 RA guard or ARP inspection can be bypassed using combinations of VLAN 0 headers and LLC/SNAP headers.