HTTP server for Cisco IOS 11.3 to 12.2 allows attackers to bypass authentication and execute arbitrary commands, when local authorization is being used, by specifying a high access level in the URL.

Cisco IOS 12.0 through 12.2, when IP routing is disabled, accepts false ICMP redirect messages, which allows remote attackers to cause a denial of service (network routing modification).

Cisco IOS 12.0 to 12.4 might allow remote attackers to execute arbitrary code via a heap-based buffer overflow in system timers. NOTE: this issue does not correspond to a specific vulnerability, rather a general weakness that only increases the feasibility of exploitation of any vulnerabilities that might exist. Such design-level weaknesses normally are not included in CVE, so perhaps this issue should be REJECTed.

Multiple memory leaks in Cisco IOS 12.0 through 12.4 allow remote attackers to cause a denial of service (device crash) via a malformed SIP packet, aka (1) CSCsf11855, (2) CSCeb21064, (3) CSCse40276, (4) CSCse68355, (5) CSCsf30058, (6) CSCsb24007, and (7) CSCsc60249.

Buffer overflow in the Next Hop Resolution Protocol (NHRP) functionality in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (restart) and execute arbitrary code via a crafted NHRP packet.

Cisco IOS 12.0, 15.0, and 15.1, when a Policy Feature Card 3C (PFC3C) is used, does not create a fragment entry during processing of an ICMPv6 ACL, which has unspecified impact and remote attack vectors, aka Bug ID CSCtj90091.

Stack-based buffer overflow in the Line Printer Daemon (LPD) in Cisco IOS before 12.2(18)SXF11, 12.4(16a), and 12.4(2)T6 allow remote attackers to execute arbitrary code by setting a long hostname on the target system, then causing an error message to be printed, as demonstrated by a telnet session to the LPD from a source port other than 515.

Unspecified vulnerability in Cisco IOS and Cisco IOS XR 12.x up to 12.3, including some versions before 12.3(15) and 12.3(14)T, allows remote attackers to obtain sensitive information (partial packet contents) or cause a denial of service (router or component crash) via crafted IPv6 packets with a Type 0 routing header.

The Simple Network Management Protocol (SNMP) subsystem of Cisco IOS 12.0 through 12.4 and 15.0 through 15.6 and IOS XE 2.2 through 3.17 contains multiple vulnerabilities that could allow an authenticated, remote attacker to remotely execute code on an affected system or cause an affected system to reload. An attacker could exploit these vulnerabilities by sending a crafted SNMP packet to an affected system via IPv4 or IPv6. Only traffic directed to an affected system can be used to exploit these vulnerabilities. The vulnerabilities are due to a buffer overflow condition in the SNMP subsystem of the affected software. The vulnerabilities affect all versions of SNMP: Versions 1, 2c, and 3. To exploit these vulnerabilities via SNMP Version 2c or earlier, the attacker must know the SNMP read-only community string for the affected system. To exploit these vulnerabilities via SNMP Version 3, the attacker must have user credentials for the affected system. All devices that have enabled SNMP and have not explicitly excluded the affected MIBs or OIDs should be considered vulnerable. Cisco Bug IDs: CSCve57697.

A vulnerability in the SNMP implementation of could allow an authenticated, remote attacker to cause a reload of the affected system or to remotely execute code. An attacker could exploit this vulnerability by sending a crafted SNMP packet to the affected device.  The vulnerability is due to a buffer overflow in the affected code area. The vulnerability affects all versions of SNMP (versions 1, 2c, and 3). The attacker must know the SNMP read only community string (SNMP version 2c or earlier) or the user credentials (SNMPv3). An exploit could allow the attacker to execute arbitrary code and obtain full control of the system or to cause a reload of the affected system. Only traffic directed to the affected system can be used to exploit this vulnerability.

The Simple Network Management Protocol (SNMP) subsystem of Cisco IOS 12.0 through 12.4 and 15.0 through 15.6 and IOS XE 2.2 through 3.17 contains multiple vulnerabilities that could allow an authenticated, remote attacker to remotely execute code on an affected system or cause an affected system to reload. An attacker could exploit these vulnerabilities by sending a crafted SNMP packet to an affected system via IPv4 or IPv6. Only traffic directed to an affected system can be used to exploit these vulnerabilities. The vulnerabilities are due to a buffer overflow condition in the SNMP subsystem of the affected software. The vulnerabilities affect all versions of SNMP: Versions 1, 2c, and 3. To exploit these vulnerabilities via SNMP Version 2c or earlier, the attacker must know the SNMP read-only community string for the affected system. To exploit these vulnerabilities via SNMP Version 3, the attacker must have user credentials for the affected system. All devices that have enabled SNMP and have not explicitly excluded the affected MIBs or OIDs should be considered vulnerable. Cisco Bug IDs: CSCve89865, CSCsy56638.

A vulnerability in the SNMP implementation of could allow an authenticated, remote attacker to cause a reload of the affected system or to remotely execute code. An attacker could exploit this vulnerability by sending a crafted SNMP packet to the affected device.  The vulnerability is due to a buffer overflow in the affected code area. The vulnerability affects all versions of SNMP (versions 1, 2c, and 3). The attacker must know the SNMP read only community string (SNMP version 2c or earlier) or the user credentials (SNMPv3). An exploit could allow the attacker to execute arbitrary code and obtain full control of the system or to cause a reload of the affected system. Only traffic directed to the affected system can be used to exploit this vulnerability.

The Simple Network Management Protocol (SNMP) subsystem of Cisco IOS 12.0 through 12.4 and 15.0 through 15.6 and IOS XE 2.2 through 3.17 contains multiple vulnerabilities that could allow an authenticated, remote attacker to remotely execute code on an affected system or cause an affected system to reload. An attacker could exploit these vulnerabilities by sending a crafted SNMP packet to an affected system via IPv4 or IPv6. Only traffic directed to an affected system can be used to exploit these vulnerabilities. The vulnerabilities are due to a buffer overflow condition in the SNMP subsystem of the affected software. The vulnerabilities affect all versions of SNMP: Versions 1, 2c, and 3. To exploit these vulnerabilities via SNMP Version 2c or earlier, the attacker must know the SNMP read-only community string for the affected system. To exploit these vulnerabilities via SNMP Version 3, the attacker must have user credentials for the affected system. All devices that have enabled SNMP and have not explicitly excluded the affected MIBs or OIDs should be considered vulnerable. Cisco Bug IDs: CSCve66601.

A vulnerability in the SNMP implementation of could allow an authenticated, remote attacker to cause a reload of the affected system or to remotely execute code. An attacker could exploit this vulnerability by sending a crafted SNMP packet to the affected device.  The vulnerability is due to a buffer overflow in the affected code area. The vulnerability affects all versions of SNMP (versions 1, 2c, and 3). The attacker must know the SNMP read only community string (SNMP version 2c or earlier) or the user credentials (SNMPv3). An exploit could allow the attacker to execute arbitrary code and obtain full control of the system or to cause a reload of the affected system. Only traffic directed to the affected system can be used to exploit this vulnerability.

The Simple Network Management Protocol (SNMP) subsystem of Cisco IOS 12.0 through 12.4 and 15.0 through 15.6 and IOS XE 2.2 through 3.17 contains multiple vulnerabilities that could allow an authenticated, remote attacker to remotely execute code on an affected system or cause an affected system to reload. An attacker could exploit these vulnerabilities by sending a crafted SNMP packet to an affected system via IPv4 or IPv6. Only traffic directed to an affected system can be used to exploit these vulnerabilities. The vulnerabilities are due to a buffer overflow condition in the SNMP subsystem of the affected software. The vulnerabilities affect all versions of SNMP: Versions 1, 2c, and 3. To exploit these vulnerabilities via SNMP Version 2c or earlier, the attacker must know the SNMP read-only community string for the affected system. To exploit these vulnerabilities via SNMP Version 3, the attacker must have user credentials for the affected system. All devices that have enabled SNMP and have not explicitly excluded the affected MIBs or OIDs should be considered vulnerable. Cisco Bug IDs: CSCve60376, CSCve78027.

Cisco IOS 11.x and 12.0 through 12.2 allows remote attackers to cause a denial of service (traffic block) by sending a particular sequence of IPv4 packets to an interface on the device, causing the input queue on that interface to be marked as full.

Cisco IOS 11.2.x and 12.0.x does not limit the size of its redirect table, which allows remote attackers to cause a denial of service (memory consumption) via spoofed ICMP redirect packets to the router.

Extended Interior Gateway Routing Protocol (EIGRP), as implemented in Cisco IOS 11.3 through 12.2 and other products, allows remote attackers to cause a denial of service (flood) by sending a large number of spoofed EIGRP neighbor announcements, which results in an ARP storm on the local network.

The IKEv1 implementation in Cisco IOS 12.2 through 12.4 and 15.0 through 15.2 and IOS XE 2.1.x through 2.6.x and 3.1.xS through 3.4.xS before 3.4.2S, 3.5.xS before 3.5.1S, and 3.2.xSG before 3.2.2SG allows remote attackers to cause a denial of service (device reload) by sending IKE UDP packets over (1) IPv4 or (2) IPv6, aka Bug ID CSCts38429.

The Multicast Source Discovery Protocol (MSDP) implementation in Cisco IOS 12.0, 12.2 through 12.4, and 15.0 through 15.2 and IOS XE 2.1.x through 2.6.x and 3.1.xS through 3.4.xS before 3.4.1S and 3.1.xSG and 3.2.xSG before 3.2.2SG allows remote attackers to cause a denial of service (device reload) via encapsulated IGMP data in an MSDP packet, aka Bug ID CSCtr28857.

The Cisco Intrusion Prevention System (IPS) and IOS with Firewall/IPS Feature Set do not properly handle certain full-width and half-width Unicode character encodings, which might allow remote attackers to evade detection of HTTP traffic.

Cisco IOS 12.0, 12.2, 12.4, 15.0, 15.1, 15.2, and 15.3 and IOS XE 2.x and 3.x before 3.7.4S; 3.2.xSE and 3.3.xSE before 3.3.2SE; 3.3.xSG and 3.4.xSG before 3.4.4SG; and 3.8.xS, 3.9.xS, and 3.10.xS before 3.10.1S allow remote attackers to cause a denial of service (device reload) via malformed RSVP packets, aka Bug ID CSCui11547.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when SIP voice services are enabled, allows remote attackers to cause a denial of service (device crash) via a valid SIP message.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when configured with (1) IP Service Level Agreements (SLAs) Responder, (2) Session Initiation Protocol (SIP), (3) H.323 Annex E Call Signaling Transport, or (4) Media Gateway Control Protocol (MGCP) allows remote attackers to cause a denial of service (blocked input queue on the inbound interface) via a crafted UDP packet.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (device reload) via a crafted Protocol Independent Multicast (PIM) packet.

A vulnerability in the Layer 2 Tunneling Protocol (L2TP) parsing function of Cisco IOS (12.0 through 12.4 and 15.0 through 15.6) and Cisco IOS XE (3.1 through 3.18) could allow an unauthenticated, remote attacker to cause an affected device to reload. The vulnerability is due to insufficient validation of L2TP packets. An attacker could exploit this vulnerability by sending a crafted L2TP packet to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability affects Cisco devices that are running a vulnerable release of Cisco IOS or Cisco IOS XE Software if the L2TP feature is enabled for the device and the device is configured as an L2TP Version 2 (L2TPv2) or L2TP Version 3 (L2TPv3) endpoint. By default, the L2TP feature is not enabled. Cisco Bug IDs: CSCuy82078.

The data-link switching (DLSw) component in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (device restart or memory consumption) via crafted (1) UDP port 2067 or (2) IP protocol 91 packets.

Cisco IOS Firewall Feature set, aka Context Based Access Control (CBAC) or Cisco Secure Integrated Software, for IOS 11.2P through 12.2T does not properly check the IP protocol type, which could allow remote attackers to bypass access control lists.

Buffer overflow in Cisco IOS 11.2.x to 12.0.x allows remote attackers to cause a denial of service and possibly execute commands via a large number of OSPF neighbor announcements.

Cisco IOS software 11.3 through 12.2 running on Cisco uBR7200 and uBR7100 series Universal Broadband Routers allows remote attackers to modify Data Over Cable Service Interface Specification (DOCSIS) settings via a DOCSIS file without a Message Integrity Check (MIC) signature, which is approved by the router.