HTTP server for Cisco IOS 11.3 to 12.2 allows attackers to bypass authentication and execute arbitrary commands, when local authorization is being used, by specifying a high access level in the URL.

Cisco IOS 12.0 through 12.2, when IP routing is disabled, accepts false ICMP redirect messages, which allows remote attackers to cause a denial of service (network routing modification).

Cisco IOS 12.0 to 12.4 might allow remote attackers to execute arbitrary code via a heap-based buffer overflow in system timers. NOTE: this issue does not correspond to a specific vulnerability, rather a general weakness that only increases the feasibility of exploitation of any vulnerabilities that might exist. Such design-level weaknesses normally are not included in CVE, so perhaps this issue should be REJECTed.

Multiple memory leaks in Cisco IOS 12.0 through 12.4 allow remote attackers to cause a denial of service (device crash) via a malformed SIP packet, aka (1) CSCsf11855, (2) CSCeb21064, (3) CSCse40276, (4) CSCse68355, (5) CSCsf30058, (6) CSCsb24007, and (7) CSCsc60249.

Buffer overflow in the Next Hop Resolution Protocol (NHRP) functionality in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (restart) and execute arbitrary code via a crafted NHRP packet.

Stack-based buffer overflow in the Line Printer Daemon (LPD) in Cisco IOS before 12.2(18)SXF11, 12.4(16a), and 12.4(2)T6 allow remote attackers to execute arbitrary code by setting a long hostname on the target system, then causing an error message to be printed, as demonstrated by a telnet session to the LPD from a source port other than 515.

Unspecified vulnerability in Cisco IOS and Cisco IOS XR 12.x up to 12.3, including some versions before 12.3(15) and 12.3(14)T, allows remote attackers to obtain sensitive information (partial packet contents) or cause a denial of service (router or component crash) via crafted IPv6 packets with a Type 0 routing header.

Cisco IOS 11.x and 12.0 through 12.2 allows remote attackers to cause a denial of service (traffic block) by sending a particular sequence of IPv4 packets to an interface on the device, causing the input queue on that interface to be marked as full.

Extended Interior Gateway Routing Protocol (EIGRP), as implemented in Cisco IOS 11.3 through 12.2 and other products, allows remote attackers to cause a denial of service (flood) by sending a large number of spoofed EIGRP neighbor announcements, which results in an ARP storm on the local network.

Memory leak in the Data-link switching (aka DLSw) feature in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xS before 3.1.3S and 3.2.xS before 3.2.1S, when implemented over Fast Sequence Transport (FST), allows remote attackers to cause a denial of service (memory consumption and device reload or hang) via a crafted IP protocol 91 packet, aka Bug ID CSCth69364.

The NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload or hang) via malformed NetMeeting Directory (aka Internet Locator Service or ILS) LDAP traffic, aka Bug ID CSCtd10712.

The Cisco Intrusion Prevention System (IPS) and IOS with Firewall/IPS Feature Set do not properly handle certain full-width and half-width Unicode character encodings, which might allow remote attackers to evade detection of HTTP traffic.

Unspecified vulnerability in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload) by sending crafted SIP packets to UDP port 5060, aka Bug ID CSCti48483.

The provider-edge MPLS NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload) via a malformed SIP packet to UDP port 5060, aka Bug ID CSCti98219.

Unspecified vulnerability in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload) by sending crafted H.323 packets to TCP port 1720, aka Bug ID CSCth11006.

Memory leak in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (memory consumption or device reload) by sending crafted SIP packets to UDP port 5060, aka Bug ID CSCtj04672.

Unspecified vulnerability in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload or hang) by sending crafted SIP packets to TCP port 5060, aka Bug ID CSCso02147.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when SIP voice services are enabled, allows remote attackers to cause a denial of service (device crash) via a valid SIP message.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when configured with (1) IP Service Level Agreements (SLAs) Responder, (2) Session Initiation Protocol (SIP), (3) H.323 Annex E Call Signaling Transport, or (4) Media Gateway Control Protocol (MGCP) allows remote attackers to cause a denial of service (blocked input queue on the inbound interface) via a crafted UDP packet.

Unspecified vulnerability in the NAT for H.323 implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1 allows remote attackers to cause a denial of service (device reload) via transit traffic, aka Bug ID CSCtf91428.

Cisco IOS 12.2 through 12.4 and 15.0 through 15.1, Cisco IOS XE 2.5.x and 2.6.x before 2.6.1, and Cisco Unified Communications Manager (aka CUCM, formerly CallManager) 6.x before 6.1(5)SU1, 7.x before 7.1(5), and 8.0 before 8.0(2) allow remote attackers to cause a denial of service (device reload or voice-services outage) via crafted SIP registration traffic over UDP, aka Bug IDs CSCtf72678 and CSCtf14987.

Cisco IOS 12.2 through 12.4 and 15.0 through 15.1, Cisco IOS XE 2.5.x and 2.6.x before 2.6.1, and Cisco Unified Communications Manager (aka CUCM, formerly CallManager) 6.x before 6.1(5), 7.0 before 7.0(2a)su3, 7.1su before 7.1(3b)su2, 7.1 before 7.1(5), and 8.0 before 8.0(1) allow remote attackers to cause a denial of service (device reload or voice-services outage) via a SIP REFER request with an invalid Refer-To header, aka Bug IDs CSCta20040 and CSCta31358.

Unspecified vulnerability in the NAT for SIP implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1 allows remote attackers to cause a denial of service (device reload) via transit traffic on UDP port 5060, aka Bug ID CSCtf17624.

Unspecified vulnerability in the NAT for H.225.0 implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1 allows remote attackers to cause a denial of service (device reload) via transit traffic, aka Bug ID CSCtd86472.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (device reload) via a crafted Protocol Independent Multicast (PIM) packet.

Cisco switches and routers running IOS 12.1 and earlier produce predictable TCP Initial Sequence Numbers (ISNs), which allows remote attackers to spoof or hijack TCP connections.

Cisco IOS Firewall Feature set, aka Context Based Access Control (CBAC) or Cisco Secure Integrated Software, for IOS 11.2P through 12.2T does not properly check the IP protocol type, which could allow remote attackers to bypass access control lists.

Cisco IOS software 11.3 through 12.2 running on Cisco uBR7200 and uBR7100 series Universal Broadband Routers allows remote attackers to modify Data Over Cable Service Interface Specification (DOCSIS) settings via a DOCSIS file without a Message Integrity Check (MIC) signature, which is approved by the router.

Multiple vulnerabilities in the H.323 protocol implementation for Cisco IOS 11.3T through 12.2T allow remote attackers to cause a denial of service and possibly execute arbitrary code, as demonstrated by the NISCC/OUSPG PROTOS test suite for the H.225 protocol.

Secure Shell (SSH) 2 in Cisco IOS 12.0 through 12.3 allows remote attackers to cause a denial of service (device reload) (1) via a username that contains a domain name when using a TACACS+ server to authenticate, (2) when a new SSH session is in the login phase and a currently logged in user issues a send command, or (3) when IOS is logging messages and an SSH session is terminated while the server is sending data.