A vulnerability in the handling of an Egress Packet Network Interface (EPNI) Aligner interrupt in Cisco IOS XR Software for Cisco Network Convergence System (NCS) 5500 Series with NC57 line cards and Cisco NCS 5700 Routers and Cisco IOS XR Software for Third Party Software could allow an unauthenticated, remote attacker to cause the network processing unit (NPU) and ASIC to stop processing, preventing traffic from traversing the interface. This vulnerability is due to the corruption of packets in specific cases when an EPNI Aligner interrupt is triggered while an affected device is experiencing heavy transit traffic. An attacker could exploit this vulnerability by sending a continuous flow of crafted packets to an interface of the affected device. A successful exploit could allow the attacker to cause persistent, heavy packet loss, resulting in a denial of service (DoS) condition. Note: If active exploitation of this vulnerability is suspected, contact the Cisco Technical Assistance Center (TAC) or your contracted maintenance provider. Cisco has assigned this security advisory a Security Impact Rating (SIR) of High rather than Medium as the score indicates. This change was made because the affected device operates within a critical network segment where compromise could lead to significant disruption or exposure, thereby elevating the overall risk beyond the base technical severity.

A vulnerability in the handling of an Egress Packet Network Interface (EPNI) Aligner interrupt in Cisco IOS XR Software for Cisco Network Convergence System (NCS) 5500 Series with NC57 line cards and Cisco NCS 5700 Routers and Cisco IOS XR Software for Third Party Software could allow an

A vulnerability in the enhanced Preboot eXecution Environment (PXE) boot loader for Cisco IOS XR 64-bit Software could allow an unauthenticated, remote attacker to execute unsigned code during the PXE boot process on an affected device. The PXE boot loader is part of the BIOS and runs over the management interface of hardware platforms that are running Cisco IOS XR Software only. The vulnerability exists because internal commands that are issued when the PXE network boot process is loading a software image are not properly verified. An attacker could exploit this vulnerability by compromising the PXE boot server and replacing a valid software image with a malicious one. Alternatively, the attacker could impersonate the PXE boot server and send a PXE boot reply with a malicious file. A successful exploit could allow the attacker to execute unsigned code on the affected device. Note: To fix this vulnerability, both the Cisco IOS XR Software and the BIOS must be upgraded. The BIOS code is included in Cisco IOS XR Software but might require additional installation steps. For further information, see the Fixed Software section of this advisory. Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability. This advisory is available at the following link:https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-iosxr-pxe-unsign-code-exec-qAa78fD2