A vulnerability in the mesh code of Cisco Wireless LAN Controller (WLC) software could allow an unauthenticated, remote attacker to impersonate a WLC in a meshed topology. The vulnerability is due to insufficient authentication of the parent access point in a mesh configuration. An attacker could exploit this vulnerability by forcing the target system to disconnect from the correct parent access point and reconnect to a rogue access point owned by the attacker. An exploit could allow the attacker to control the traffic flowing through the impacted access point or take full control of the target system. This vulnerability affects the following products running a vulnerable version of Wireless LAN Controller software and configured for meshed mode: Cisco 8500 Series Wireless Controller, Cisco 5500 Series Wireless Controller, Cisco 2500 Series Wireless Controller, Cisco Flex 7500 Series Wireless Controller, Cisco Virtual Wireless Controller, Wireless Services Module 2 (WiSM2). Note that additional configuration is needed in addition to upgrading to a fixed release. Cisco Bug IDs: CSCuc98992 CSCuu14804.
The IGMP implementation on Cisco Wireless LAN Controller (WLC) devices 4.x, 5.x, 6.x, 7.0 before 7.0.250.0, 7.1, 7.2, and 7.3, when IGMPv3 Snooping is enabled, allows remote attackers to cause a denial of service (memory over-read and device restart) via a crafted field in an IGMPv3 message, aka Bug ID CSCuh33240.
Cisco Wireless LAN Controller (WLC) devices 7.2, 7.3, and 7.4 before 7.4.110.0 allow remote attackers to cause a denial of service (device restart) via a crafted 802.11 Ethernet frame, aka Bug ID CSCuf80681.
The multicast listener discovery (MLD) service on Cisco Wireless LAN Controller (WLC) devices 7.2, 7.3, 7.4 before 7.4.121.0, and 7.5, when MLDv2 Snooping is enabled, allows remote attackers to cause a denial of service (device restart) via a malformed IPv6 MLDv2 packet, aka Bug ID CSCuh74233.
Cisco Wireless LAN Controller (WLC) devices 7.2 before 7.2.115.2, 7.3, and 7.4 before 7.4.110.0 allow remote attackers to cause a denial of service (device restart) via a crafted 802.11 Ethernet frame, aka Bug ID CSCue87929.
Cisco Wireless LAN Controller (WLC) devices 7.4 before 7.4.110.0 distribute Aironet IOS software with a race condition in the status of the administrative HTTP server, which allows remote attackers to bypass intended access restrictions by connecting to an Aironet access point on which this server had been disabled ineffectively, aka Bug ID CSCuf66202.
Cisco Wireless LAN Controller (WLC) devices 7.0 before 7.0.250.0, 7.2, 7.3, and 7.4 before 7.4.110.0 do not properly deallocate memory, which allows remote attackers to cause a denial of service (reboot) by sending WebAuth login requests at a high rate, aka Bug ID CSCuf52361.
The Cisco Wireless LAN Controller (WLC), Cisco Catalyst 6500 Wireless Services Module (WiSM), and Cisco Catalyst 3750 Integrated Wireless LAN Controller with software 4.x before 4.2.176.0 and 5.2.x before 5.2.157.0 allow remote attackers to cause a denial of service (device reload) via a web authentication (aka WebAuth) session that includes a malformed POST request to login.html.
Unspecified vulnerability in the Wireless LAN Controller (WLC) TSEC driver in the Cisco 4400 WLC, Cisco Catalyst 6500 and 7600 Wireless Services Module (WiSM), and Cisco Catalyst 3750 Integrated Wireless LAN Controller with software 4.x before 4.2.176.0 and 5.x before 5.1 allows remote attackers to cause a denial of service (device crash or hang) via unknown IP packets.
The Cisco Wireless LAN Controller (WLC), Cisco Catalyst 6500 Wireless Services Module (WiSM), and Cisco Catalyst 3750 Integrated Wireless LAN Controller with software 4.x before 4.2.176.0 and 5.x before 5.2 allow remote attackers to cause a denial of service (web authentication outage or device reload) via unspecified network traffic, as demonstrated by a vulnerability scanner.
Unspecified vulnerability in the Cisco Wireless LAN Controller (WLC), Cisco Catalyst 6500 Wireless Services Module (WiSM), and Cisco Catalyst 3750 Integrated Wireless LAN Controller with software 4.2.173.0 allows remote authenticated users to gain privileges via unknown vectors, as demonstrated by escalation from the (1) Lobby Admin and (2) Local Management User privilege levels.
A vulnerability in TACACS authentication with Cisco Wireless LAN Controller (WLC) Software could allow an authenticated, local attacker to perform certain operations within the GUI that are not normally available to that user on the CLI. The vulnerability is due to incorrect parsing of a specific TACACS attribute received in the TACACS response from the remote TACACS server. An attacker could exploit this vulnerability by authenticating via TACACS to the GUI on the affected device. A successful exploit could allow an attacker to create local user accounts with administrative privileges on an affected WLC and execute other commands that are not allowed from the CLI and should be prohibited.
A vulnerability in the handling of Inter-Access Point Protocol (IAPP) messages by Cisco Wireless LAN Controller (WLC) Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition. The vulnerability exist because the software improperly validates input on fields within IAPP messages. An attacker could exploit the vulnerability by sending malicious IAPP messages to an affected device. A successful exploit could allow the attacker to cause the Cisco WLC Software to reload, resulting in a DoS condition. Software versions prior to 8.2.170.0, 8.5.150.0, and 8.8.100.0 are affected.
A vulnerability in the handling of Inter-Access Point Protocol (IAPP) messages by Cisco Wireless LAN Controller (WLC) Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition. The vulnerability exist because the software improperly validates input on fields within IAPP messages. An attacker could exploit the vulnerability by sending malicious IAPP messages to an affected device. A successful exploit could allow the attacker to cause the Cisco WLC Software to reload, resulting in a DoS condition. Software versions prior to 8.2.170.0, 8.5.150.0, and 8.8.100.0 are affected.
A vulnerability in the handling of Inter-Access Point Protocol (IAPP) messages by Cisco Wireless LAN Controller (WLC) Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition. The vulnerability exist because the software improperly validates input on fields within IAPP messages. An attacker could exploit the vulnerability by sending malicious IAPP messages to an affected device. A successful exploit could allow the attacker to cause the Cisco WLC Software to reload, resulting in a DoS condition. Software versions prior to 8.2.170.0, 8.5.150.0, and 8.8.100.0 are affected.
A vulnerability in Cisco Aironet Access Points (APs) could allow an unauthenticated, remote attacker to cause a denial of service (DoS) on an affected device. The vulnerability is due to improper resource management while processing specific packets. An attacker could exploit this vulnerability by sending a series of crafted UDP packets to a specific port on an affected device. A successful exploit could either allow the attacker to tear down the connection between the AP and the wireless LAN controller, resulting in the affected device not being able to process client traffic, or cause the vulnerable device to reload, triggering a DoS condition. After the attack, the affected device should automatically recover its normal functions without manual intervention.
A vulnerability in Cisco Aironet Access Point (AP) Software could allow an unauthenticated, remote attacker to cause an affected device to reload. The vulnerability is due to improper handling of clients that are trying to connect to the AP. An attacker could exploit this vulnerability by sending authentication requests from multiple clients to an affected device. A successful exploit could allow the attacker to cause the affected device to reload.
A vulnerability in the Ethernet packet handling of Cisco Aironet Access Points (APs) Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by connecting as a wired client to the Ethernet interface of an affected device and sending a series of specific packets within a short time frame. A successful exploit could allow the attacker to cause a NULL pointer access that results in a reload of the affected device.
Cisco Wireless LAN Controller (WLC) devices do not properly address the resource consumption of terminated TELNET sessions, which allows remote attackers to cause a denial of service (TELNET outage) by making many TELNET connections and improperly ending these connections, aka Bug ID CSCug35507.
The mDNS snooping functionality on Cisco Wireless LAN Controller (WLC) devices with software 7.4.1.54 and earlier does not properly manage buffers, which allows remote authenticated users to cause a denial of service (device reload) via crafted mDNS packets, aka Bug ID CSCue04153.
Multiple cross-site request forgery (CSRF) vulnerabilities on Cisco Wireless LAN Controller (WLC) devices with software 7.2.110.0 allow remote attackers to hijack the authentication of administrators for requests that (1) add administrative accounts via screens/aaa/mgmtusercreate.html or (2) insert XSS sequences via the headline parameter to screens/base/webauthcustom.html, aka Bug ID CSCud50283.
Cisco Wireless LAN Controller (WLC) software, possibly 4.2 through 6.0, allows remote authenticated users to bypass intended access restrictions and modify the configuration, and possibly obtain administrative privileges, via unspecified vectors, a different vulnerability than CVE-2010-2842 and CVE-2010-2843.
Cisco 4100 and 4400, Airespace 4000, and Catalyst 6500 and 3750 Wireless LAN Controller (WLC) software 4.1 before 4.1.180.0 allows remote attackers to cause a denial of service (ARP storm) via a broadcast ARP packet that "targets the IP address of a known client context", aka CSCsj50374.
Cisco 4100 and 4400, Airespace 4000, and Catalyst 6500 and 3750 Wireless LAN Controller (WLC) software before 3.2 20070727, 4.0 before 20070727, and 4.1 before 4.1.180.0 allows remote attackers to cause a denial of service (traffic amplification or ARP storm) via a crafted unicast ARP request that (1) has a destination MAC address unknown to the Layer-2 infrastructure, aka CSCsj69233; or (2) occurs during Layer-3 roaming across IP subnets, aka CSCsj70841.
Cisco Wireless LAN Controller (WLC) before 3.2.116.21, and 4.0.x before 4.0.155.0, allows remote attackers on a local network to cause a denial of service (device crash) via malformed Ethernet traffic.
The SNMP implementation in the Cisco Wireless LAN Controller (WLC) before 20070419 uses the default read-only community public, and the default read-write community private, which allows remote attackers to read and modify SNMP variables, aka Bug ID CSCse02384.
The Network Processing Unit (NPU) in the Cisco Wireless LAN Controller (WLC) before 3.2.171.5, 4.0.x before 4.0.206.0, and 4.1.x allows remote attackers on a local wireless network to cause a denial of service (loss of packet forwarding) via (1) crafted SNAP packets, (2) malformed 802.11 traffic, or (3) packets with certain header length values, aka Bug IDs CSCsg15901 and CSCsh10841.
Cisco Aironet 1000 Series and 1500 Series Lightweight Access Points before 3.2.185.0, and 4.0.x before 4.0.206.0, have a hard-coded password, which allows attackers with physical access to perform arbitrary actions on the device, aka Bug ID CSCsg15192.
Cross-site scripting (XSS) vulnerability in the management interface on Cisco Wireless LAN Controller (WLC) devices allows remote attackers to inject arbitrary web script or HTML via a crafted URL, aka Bug ID CSCuf77810.
Cisco Wireless LAN Controller (WLC) devices with software 7.0 before 7.0.235.3, 7.1 and 7.2 before 7.2.111.3, and 7.3 before 7.3.101.0 allow remote authenticated users to bypass wireless-management settings and read or modify the device configuration via an SNMP request, aka Bug ID CSCua60653.