D-Link DSL-2750B devices before 1.05 allow remote unauthenticated command injection via the login.cgi cli parameter, as exploited in the wild in 2016 through 2022.
A vulnerability classified as critical was found in D-Link DAP-1360, DIR-300, DIR-615, DIR-615GF, DIR-615S, DIR-615T, DIR-620, DIR-620S, DIR-806A, DIR-815, DIR-815AC, DIR-815S, DIR-816, DIR-820, DIR-822, DIR-825, DIR-825AC, DIR-825ACF, DIR-825ACG1, DIR-841, DIR-842, DIR-842S, DIR-843, DIR-853, DIR-878, DIR-882, DIR-1210, DIR-1260, DIR-2150, DIR-X1530, DIR-X1860, DSL-224, DSL-245GR, DSL-2640U, DSL-2750U, DSL-G2452GR, DVG-5402G, DVG-5402G, DVG-5402GFRU, DVG-N5402G, DVG-N5402G-IL, DWM-312W, DWM-321, DWR-921, DWR-953 and Good Line Router v2 up to 20240112. This vulnerability affects unknown code of the file /devinfo of the component HTTP GET Request Handler. The manipulation of the argument area with the input notice|net|version leads to information disclosure. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used. VDB-251542 is the identifier assigned to this vulnerability.
A vulnerability classified as problematic has been found in D-Link DSL-2750U R5B017. This affects an unknown part of the component Port Forwarding Page. The manipulation of the argument PortMappingDescription leads to cross site scripting. It is possible to initiate the attack remotely.
UNSUPPORTED WHEN ASSIGNED D-Link (Non-US) DSL-2750U N300 ADSL2+ and (Non-US) DSL-2730U N150 ADSL2+ are vulnerable to Incorrect Access Control. The UART/Serial interface on the PCB, provides log output and a root terminal without proper access control.
DISPUTED D-Link DSL-2750U 1.11 is affected by: Authentication Bypass. The impact is: denial of service and information leakage. The component is: login. NOTE: Third parties dispute this issues as not being a vulnerability because although the wizard is accessible without authentication, it can't actually configure anything. Thus, there is no denial of service or information leakage.
D-link DSL-2750U ISL2750UEME3.V1E devices allow approximately 90 seconds of access to the control panel, after a restart, before MAC address filtering rules become active.