ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.2, 5.4.3, 5.3.4, 5.2.6, and 5.1.6, a vulnerability exists in the WPS (Wi-Fi Protected Setup) Enrollee implementation where malformed EAP-WSC packets with truncated payloads can cause integer underflow during fragment length calculation. When processing EAP-Expanded (WSC) messages, the code computes fraglen by subtracting header sizes from the total packet length. If an attacker sends a packet where the EAP Length field covers only the header and flags but omits the expected payload (such as the 2-byte Message Length field when WPSMSGFLAGLEN is set), fraglen becomes negative. This negative value is then implicitly cast to sizet when passed to wpabufputdata(), resulting in a very large unsigned value. This issue has been patched in versions 5.5.3, 5.4.4, 5.3.5, 5.2.7, and 5.1.7.

ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.2, 5.4.3, 5.3.4, 5.2.6, and 5.1.6, an out-of-bounds read vulnerability was reported in the BLE ATT Prepare Write handling of the BLE provisioning transport (protocommble). The issue can be triggered by a remote BLE client while the device is in provisioning mode. The transport accumulated prepared-write fragments in a fixed-size buffer but incorrectly tracked the cumulative length. By sending repeated prepare write requests with overlapping offsets, a remote client could cause the reported length to exceed the allocated buffer size. This inflated length was then passed to provisioning handlers during execute-write processing, resulting in an out-of-bounds read and potential memory corruption. This issue has been patched in versions 5.5.3, 5.4.4, 5.3.5, 5.2.7, and 5.1.7.

ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.2, 5.4.3, 5.3.4, 5.2.6, and 5.1.6, a use-after-free vulnerability was reported in the BLE provisioning transport (protocommble) layer. The issue can be triggered by a remote BLE client while the device is in provisioning mode. The vulnerability occurred when provisioning was stopped with keepbleon = true. In this configuration, internal protocommble state and GATT metadata were freed while the BLE stack and GATT services remained active. Subsequent BLE read or write callbacks dereferenced freed memory, allowing a connected or newly connected client to trigger invalid memory acces. This issue has been patched in versions 5.5.3, 5.4.4, 5.3.5, 5.2.7, and 5.1.7.

ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In 5.5.1, 5.4.3, 5.3.4, 5.2.6, 5.1.6, and earlier, when AVRCP is enabled on ESP32, receiving a malformed VENDOR DEPENDENT command from a peer device can cause the Bluetooth stack to access memory before validating the command buffer length. This may lead to an out-of-bounds read, potentially exposing unintended memory content or causing unexpected behavior.

ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. An integer underflow vulnerability has been identified in the ESP-NOW protocol implementation within the ESP Wi-Fi component of versions 5.4.1, 5.3.3, 5.2.5, and 5.1.6 of the ESP-IDF framework. This issue stems from insufficient validation of user-supplied data length in the packet receive function. Under certain conditions, this may lead to out-of-bounds memory access and may allow arbitrary memory write operations. On systems without a memory protection scheme, this behavior could potentially be used to achieve remote code execution (RCE) on the target device. In versions 5.4.2, 5.3.4, 5.2.6, and 5.1.6, ESP-NOW has added more comprehensive validation logic on user-supplied data length during packet reception to prevent integer underflow caused by negative value calculations. For ESP-IDF v5.3 and earlier, a workaround can be applied by validating that the datalen parameter received in the RX callback (registered via espnowregisterrecvcb()) is a positive value before further processing. For ESP-IDF v5.4 and later, no application-level workaround is available. Users are advised to upgrade to a patched version of ESP-IDF to take advantage of the built-in mitigation.

ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.1, 5.4.3, 5.3.4, 5.2.6, 5.1.6, and earlier, in the ESP-IDF Bluetooth host stack (BlueDroid), the function btadmsdpresult() used a fixed-size array uuidlist[32][MAXUUIDSIZE] to store discovered service UUIDs during the SDP (Service Discovery Protocol) process. On modern Bluetooth devices, it is possible for the number of available services to exceed this fixed limit (32). In such cases, if more than 32 services are discovered, subsequent writes to uuidlist could exceed the bounds of the array, resulting in a potential out-of-bounds write condition.

ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.1, 5.4.3, 5.3.4, 5.2.6, 5.1.6, and earlier, in the avrcvendormsg() function of the ESP-IDF BlueDroid AVRCP stack, the allocated buffer size was validated using AVRCMINCMDLEN (20 bytes). However, the actual fixed header data written before the vendor payload exceeds this value. This totals 29 bytes written before pmsg->pvendordata is copied. Using the old AVRCMINCMDLEN could allow an out-of-bounds write if vendorlen approaches the buffer limit. For commands where vendorlen is large, the original buffer allocation may be insufficient, causing writes beyond the allocated memory. This can lead to memory corruption, crashes, or other undefined behavior. The overflow could be larger when assertions are disabled.